West-control-solutions MRC 7000 Controller Manual Uživatelský manuál stáhnout pdf (Strana 20)

Configuration 3.1

After completing installation and wiring of the instrument the configuration (set up) procedures

must be performed to prepare the instrument for operation on the intended application. The

procedures include selecting specific parameters, entering data and possible jumper position-

ing. Once properly configured the instrument will retain the user selections in memory so this

procedure need not be repeated unless required by changes in the application.

Parameter selections and data entry are made via the front keypad. To ease configuration

and operation, user entered data has been divided up into several sections referred to as

modes. Each mode contains a different type of data or may be used for specific operating

functions. For two pen instruments, some modes are common to both pens. These modes are

as follows:

MODE DISPLAY CODE FUNCTION DESCRIPTION

Off oFF Operation Outputs and Alarms

are Off

Chart may stop

rotating(selectable)

Control CtrL Control Outputs and Alarms

are Active

Test tESt Service Tests Instrument

Operation

Calibration CAL Service Calibrates, Resets

Instrument

Program Prog Configuration Configure Operating

Parameters

Tune tunE Configuration & Enter Tune and

Operation Alarm Settings

Setpoint Selection SPS Operation Selects Remote or

Local Setpoint

Operation (Remote

Setpoint Optional)

Manual Stby Operation Provides for manual

operation of

proportional output

Enable EnAb Configuration Mode security

system, can lock out

everything except Off

and Control (See

Appendix A-1, page

62, for hardware

lockout information)

Associated with each mode is a series of unique displays that are accessed via the front

keypad.

Prior to first time operation of the instrument, the configuration procedures for the Program

and Tune modes must be performed as applicable. Calibration and Test modes are not used

as part of the instrument configuration or operation. These are used for service and mainte-

nance functions and are discussed in Section 5.4 & 5.5 of this manual (page 46 - 54).

Control

(CtrL)

Test

(tESt)

Program

(Prog)

Tune

(tunE)

Setpoint Select

(SPS)

Calibrate

(CAL)

Standby

(Stby)

OFF

(oFF)

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 73 74

Komentáře k této Příručce

Žádné komentáře

West-control-solutions MRC 7000 Controller Manual Uživatelský manuál Strana 20

Komentáře k této Příručce

Související produkty a manuály pro Zařízení West-control-solutions MRC 7000 Controller Manual